Breeding season begins!

Photo: Mike and Carl took the flock down the road again. This time from the North Farm to the Home Farm. The total distance was about a mile. I was stuck back at the home farm with a ATV with a flat tire. I patched it and filled it with air in time to catch the guys closing the gate to the new pasture. 

It's that time of year at Premier. The rams have been brought out of storage and have been put to work in the pastures. On Monday Mike and I put a marking harness on each of the two Hampshire rams Premier acquired earlier this year.

Photo: The wooled ewes taking a walk to their new pasture. Within a few days we sent the rams in with them to start the breeding season. 

Tharren came out to take photos for a set of "how-to" instructions for the marking harnesses. We used both the cross your heart harness and the nylon harness. The nylon harness is designed for larger animals and the cross your heart fits goats and smaller rams with a more pointed brisket.

Photo: We scratched the crayon with the pin before inserting it into the harness. The mark identifies where the pin holes are on the crayon. This allows us to quickly line up the holes and insert the pin.  

The temperatures have been in the 65˚ range during the day. We used mild marking crayons which are designed to be used in 65˚-85˚ F temperature ranges. There are also cold and hot crayons. Cold crayons work best in temperatures below 65˚ and hot crayons work best above 85˚F. We chose mild assuming that the rams would be more active during the day than during the night.

Photo: Mike using a braided rope halter to pose the ram for a photo. The marking crayon in the cross your heart harness is a little high on the rams chest. It should sit between the legs. The correct position allows for optimal marking when the ram dismounts the ewe. 

Once the harnesses were on and the marking crayons inserted we took the rams out to the pasture. I noticed that the crayons were a little high on the rams chest and questioned myself on the effectiveness of crayons in a higher than recommended position. We waited a few minutes to see if the crayons would leave marks and they did. I would have preferred to re-adjust the harness in the field but it would be a little difficult to catch the rams in the open pasture. However, we will be bringing the flock in this week to ear tag the ewes and document which ones have been marked. While the flock is in the handling yards, we will re-adjust the harness so they would fit properly.

Photo: The rams on their way out to the pasture. They will be with 125 ewes for a few weeks. We plan to switch rams after a few weeks. But the first lambs dropped will be from these fellas. 

The ear tags we insert will be used to help make our lambing season less stressful. How? We will write down the tag number of each ewe and also the time frame she was expected to have been bred in. The ewes will be brought in shortly before they're due to lamb and we'll sort off the "soons" so they can be brought into the lambing jugs.  

Photo: It didn't take long for the rams to mark some of the ewes. I was happy that the high crayon placement still left a mark on the ewe. 

Photo: This ram is wearing the nylon harness. The yellow crayon he is wearing marked the ewes very well. We will switch crayon colors during the season to signify different breeding times/different sires. 

Ideally we would have put the harnesses on the rams a day or two before we sent them out to the ewes. This would have allowed the rams to get used to wearing the harness and allowed us to properly adjust it. Harnesses typically only need one adjustment after the initial installation.